Jet Tools JWBS-14CS, JWBS-14OS operating instructions

Page 10

7.Place motor over rubber grommets and fasten to stand top with four hex cap screws, eight flat washers, four lock washers, and four hex nuts, as shown in item C, page 7. See Figure 4. The arrangement of these fasteners is shown in Figure 5. Do not tighten at this time.

8.Align the motor pulley with the large pulley using a straight edge against the flat sides of the pulleys, as shown in Figure 6. The pulleys should lie in a straight plane (Figure 7). Slide the motor as needed to align the pulleys. If further adjustment is required, loosen the set screw in one or more of the pulleys and move the pulley(s) until they line up. Tighten set screw(s).

IMPORTANT: When moving the pulleys, do not position them beyond the end of the shaft. Both pulleys must fully engage the shaft and the key.

Figure 4

Figure 5

Figure 6

Figure 7

10

Image 10
Contents Inch Woodworking Band Saw Part No. M-708115Warranty and Service More Information WMH Tool Group WarrantyTable of Contents Page Page Introduction Specifications JWBS-14OSUnpacking JWBS-14OS Contents of the Shipping ContainerFasteners Strain Relief Plate to Stand Unpacking JWBS-14CSSaw Body to Stand Trunnion Support Bracket to Saw Body Pulley Cover to Base 2 KnobsAssembly of JWBS-14OS Tools Required for AssemblyPage Page Assembly of JWBS-14CS Page Grounding Instructions Volt Operation Volt ConversionExtension Cords AdjustmentsAdjusting 90 Table Stop Tilting the TableAdjusting Blade Tension Changing BladesAdjusting Blade Tracking Adjusting Upper Blade Guide AssemblyAdjusting Blade Guide and Blade Support Bearing Repeated Trouble Troubleshooting JWBS-14CS/OS Band SawProbable Cause Remedy Optional Accessories Accessory BladesReplacement Parts Body Assembly JWBS-14CS/OS Band Saw Index No. Part No Description Size QtyJWBS14-HK Body Assembly JWBS-14CS/OS Band Saw Closed Stand Assembly JWBS-14CS Band Saw Closed Stand Assembly JWBS14-CS Band Saw Open Stand Assembly JWBS-14OS Band Saw Open Stand Assembly JWBS-14OS Band Saw Electrical Connections 115 volt JWBS-14CS/OS Band Saw Electrical Connections 230 volt JWBS-14CS/OS Band Saw WMH Tool Group