Jet Tools JWBS-14CS operating instructions Assembly of JWBS-14OS, Tools Required for Assembly

Page 9

Assembly of JWBS-14OS

NOTE: If any of the assembly procedures need further clarification, refer to the exploded views in the back of this manual.

Tools Required for Assembly

Metric combination wrench set and adjustable wrench

#1 and #2 cross point screwdrivers

1.Place stand top upside down on a level surface. Fasten four stand legs to stand top using carriage bolts, washers, lock washers, and nuts, as shown in item A on page 7. Note: Stand legs fasten to outside of stand top (Figure 1). Do not tighten at this time.

2.Fasten two long braces and two short braces to stand legs using carriage bolts, washers, lock washers, and nuts, as shown in item A, page 7. Do not tighten at this time. See Figure 2.

3.Turn assembly over and stand it on its legs. Push down slightly on the top to make sure the stand settles properly and all four legs sit flat on a level surface. Tighten all nuts.

Saw body is heavy! Use caution when lifting and stabilize until firmly attached to the stand! Failure to comply may cause serious injury!

4.With the aid of a second person, lift the saw body out of the shipping container and place onto the stand top. Be sure front of saw (with JET logo) faces stand front (JET logo). See photo on cover for orientation.

5.Line up holes in saw body with holes in stand. Place support plate to the underside of stand as shown in the parts diagram for the open stand assembly (item 5, page 30). Fasten saw body, stand, and support plate together with four hex cap screws, eight flat washers, four lock washers, and four hex nuts, as shown in item B on page 7.

6.To mount the motor, place four rubber grommets over holes in stand top (Figure 3). Note: Use of rubber grommets is essential for eliminating excessive vibration.

9

Figure 1

Figure 2

Figure 3

Image 9
Contents Part No. M-708115 Inch Woodworking Band SawMore Information WMH Tool Group Warranty Warranty and ServiceTable of Contents Page Page JWBS-14OS Introduction SpecificationsContents of the Shipping Container Unpacking JWBS-14OSFasteners Saw Body to Stand Trunnion Support Bracket to Saw Body Unpacking JWBS-14CSStrain Relief Plate to Stand Pulley Cover to Base 2 KnobsTools Required for Assembly Assembly of JWBS-14OSPage Page Assembly of JWBS-14CS Page Grounding Instructions Volt Conversion Volt OperationAdjusting 90 Table Stop AdjustmentsExtension Cords Tilting the TableChanging Blades Adjusting Blade TensionAdjusting Upper Blade Guide Assembly Adjusting Blade TrackingAdjusting Blade Guide and Blade Support Bearing Repeated Troubleshooting JWBS-14CS/OS Band Saw TroubleProbable Cause Remedy Accessory Blades Optional AccessoriesReplacement Parts Index No. Part No Description Size Qty Body Assembly JWBS-14CS/OS Band SawJWBS14-HK Body Assembly JWBS-14CS/OS Band Saw Closed Stand Assembly JWBS-14CS Band Saw Closed Stand Assembly JWBS14-CS Band Saw Open Stand Assembly JWBS-14OS Band Saw Open Stand Assembly JWBS-14OS Band Saw Electrical Connections 115 volt JWBS-14CS/OS Band Saw WMH Tool Group Electrical Connections 230 volt JWBS-14CS/OS Band Saw