Jet Tools JWBS-14CS Unpacking JWBS-14OS, Contents of the Shipping Container, Fasteners

Unpacking – JWBS-14OS

Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.

Contents of the Shipping Container

1	Stand top with motor support plate	1	V-belt
4	Stand legs	1	Pulley cover
2	Cross braces-short	2	Table lock knobs
2	Cross braces-long	1	Table pin
1	Stand support plate	1	Trunnion support bracket
1	Saw body	1	Fastener package (see below)
1	Table	1	Instruction Manual
1	Motor	1	Warranty Card

Fasteners

A. Stand Assembly (partial quantity shown)			4	– rubber grommets
40		– M8x16 carriage bolts	4	– M8 lock washers
40		– M8 flat washers	4	– M8 hex nuts
40		– M8 lock washers	D. Pulley Cover to Stand
40		– M8 hex nuts
B. Saw Body to Stand			3	– M5x12 pan head screws (approx. 1/2”)
			6	– M5 flat washers
4	– M8x40 hex cap screws (approx. 1-1/2")		3	– M5 hex nuts
8	– M8 flat washers		E. Trunnion Support Bracket to Saw Body
4	– M8 lock washers
4	– M8 hex nuts		2	– M8x30 hex cap screws (approx. 1-1/4")
C. Motor to Stand			2	– M8 lock washers
			1	– M8x80 hex cap screw (for table stop -
4	– M8x35 hex cap screws (approx. 1-3/8”)			approx. 3-1/8” long)
8	– M8 flat washers		1	– M8 hex nut (for table stop)

7