Table Insert, Miter Gauge | Jet Tools JPS-10TS specs

If alignment is required:

3.Move the straight-edge aside and through the opening (see inset) locate four hex nuts (F, G) and two retaining plates (H) that secure the splitter tab (J).

4.Slightly loosen the hex nuts (F, G).

5.To move the splitter (E) right or left, adjust all four nuts evenly to move the retaining plate and tab accordingly. To tilt the angle of the splitter to achieve alignment, adjust the two front hex nuts (F) or two rear hex nuts (G) only.

6.When adjustment is complete, tighten the hex nuts (F, G).

7.Check the alignment by repeating steps 1 and 2. If necessary, repeat steps 3–6 until proper alignment is achieved.

Table Insert

Referring to Figure 15:

1.Raise the blade guard assembly.

2.Lower the blade completely.

3.Place the table insert (A) into the opening with the notched end (B) towards the splitter (C).

4.Adjust the insert (A) flush with the table by turning four leveling setscrews (D) and using a straight edge (E). A 2.5mm hex wrench is required to adjust the setscrews.

Miter Gauge

Operation

Referring to Figure 16:

Operate the miter gauge by loosening the lock knob (A) and turning the miter body (B) to the desired angle.

The pin (C) functions as an index stop. When pushed in, the body will stop at -45º, 90º or +45º when turned, as one of three screws (D) located underneath the miter hits the pin.

You can adjust the play in the miter gauge by tightening the set screw (E)

Calibration

If a miter angle at the -45º, 90º or +45º is not correct, the index stops can be adjusted by turning one of three adjustment screws (D), then locking the hex nut.

Note: Always make test cuts. Do not rely solely on miter gauge indicator marks.

Figure 14

Figure 15

Figure 16