TROUBLESHOOTING (continued)
Symptom and Checklist (continued)
Symptoms |
| Checklist |
| Page | |
|
|
|
| ||
| Check the volume level. |
| 27 , | ||
Normal picture, but no sound | Check if the | button has been pressed or not. | |||
14 ~ 15 | |||||
| Check the connections to external equipment. | ||||
|
| ||||
|
|
| |||
No picture - normal sound | Check the level of “Brightness” and “Contrast” in UT Monitor “Picture Menu”. |
| |||
|
|
|
| ||
| Check if the batteries are installed correctly. |
| 13 | ||
The remote control does not work. | The batteries might be exhausted. Replace them with new ones. | ||||
| Remove all obstructions from in front of the sensor window on the unit. |
| |||
Picture Frezze and/or the buttons on | Unplug and connect after 5 minutes the power cord or turn Main switch Off |
| |||
both the remote control and control | and On after 5 minutes both A/V Center and UT Monitor. |
| |||
Hold down the Reset button on the UT Monitor control panel for over a |
| ||||
panel do not work. |
| ||||
second. |
|
|
| ||
Normal picture but no | Check the connections to external equipment. | 14 ~ 15 | |||
|
|
| |||
No picture | Check if the power cord is plugged into the socket securely for UT Monitor. | 10 | |||
UT Monitor Indicating lamp → Off | Check if the main switch is on for UT Monitor. |
| |||
|
| ||||
|
|
| |||
No picture | Check if the A/V Center to UT Monitor cable is connected correctly and | 35 , | |||
UT Indicating lamp → Orange | securely. |
|
| ||
It means that UT monitor is in “Power | Check if the power of the A/V Center is ON. |
| 14 ~ 15 | ||
Save mode”. | Refer to “When the Following Messages Appears on the Screen”. |
| |||
|
|
| |||
| Check if the signal cable is connected correctly and securely. |
| |||
No picture | Check if the A/V Center to UT Monitor cable is connected correctly and | 14 ~ 15 | |||
UT Monitor indicating lamp → Green | securely. |
|
| ||
|
|
| |||
| Adjust the level of Brightness and Contrast lower. |
| |||
|
|
| |||
The top of the unit and surface of the | This may occur if you use the unit for a long time. Turn off the main power |
| |||
panel heat up. | to the unit for a while. Please note that this is not a malfunction. |
| |||
|
|
|
|
| |
|
| INFO |
|
| |
Some screen display aspects are not | Check the signal status by pressing the | button on the remote control. | 18 | ||
The available screen display aspect is different depending on the current | |||||
possible. | |||||
signal status. |
|
|
| ||
|
|
|
| ||
|
|
| |||
Some digital programming looks blurry | This is normal and its due regular digital compression scheme, please note |
| |||
during fast changing scenes.. | this is not a malfunction. |
|
| ||
|
|
| |||
Turns Off by itself | Check or ensure Timer settings are not activated. | 29 | |||
|
|
|
|
| |
Picture may “block” or freeze when | Check signal strength and noise levels under ”Signal Meter” | 28 | |||
watching a digital channel. | |||||
|
|
|
| ||
|
|
|
|
|
ENGLISH
36