Jet Tools J-3410-2 operating instructions Replacement Parts, WMH Tool Group

Page 25

Replacement Parts

This section provides exploded view illustrations that show the replacement parts for the Model J-3410 and J-3410-2 7-Inch x 12-Inch Horizontal Cut-Off Band Saw. Also provided are parts listings that provide part number and description. The item numbers shown on the illustration relate to the item number in the facing parts listing.

Order replacement parts from:

WMH Tool Group

427 New Sanford Road

LaVergne, Tennessee 30786

Ph: 800-274-6848

www.wmhtoolgroup.com

Identify the replacement part by the part number shown in the parts listing. Be sure to include the model number and serial number of your machine when ordering replacement parts to assure that you will receive the correct part.

25

Image 25

Contents

7x12 Cut-off Band Saw Life Table of Contents General Specifications Machinery general safety warnings General Electrical Cautions Safety instructions on sawing systemsLocking vise jaw Using the viseAdjusting stationary jaw angle cuts Adjusting stationary jaw straight cutsChanging the locking jaw location Stationary vise jawSetting the blade guides Adjusting angles with the scale on the saw tableControlling the cut Hydraulic feed control Using the stock stop for repeated cutsChanging blade speeds Blade break-in proceduresBlade selection Evaluating cutting efficiencyAngle cutting Right angle cuts -- single pieces of stockSuggested cutting speeds Placing workpieces in the vise To adjust blade tracking Adjusting blade trackingReplacing blades When to adjust the blade guides Blade alignment adjustmentsReplacing blade guide and support components Adjust blade for parallelismTest cutting to verify adjustment accuracy Adjusting blade verticalAdjusting blade back-up bearings Adjusting guide bearingsReplacing guide bearings Replacing the drive wheel Installing the vertical sawing tableReplacing idler wheel or bearings Hydraulic control cylinder exploded view Servicing the hydraulic control cylinder Electrical Uncrating and spotting the saw To change the operating voltage Chip brush replacement Installing the coolant kitAdjusting the horizontal stop and motor switch To replace or adjust the hori- zontal stopProblem Probable cause Potential solutions TroubleshootingTions WMH Tool Group Replacement PartsExploded View Saw Head Part.no Description Qty Parts List Saw HeadExploded View Saw Base Description Qty Parts List Saw BaseDescription Parts List Hydraulic CylinderPage WMH Tool Group