Mitsubishi Electronics WD-65737, WD-52527, WD-73837, WD-73737, WD-65C9, WD-60737 Lower Duct Removal

MODELS: WD-60C9 / WD-65C9 / WD-73C9 / WD-60737 / WD-65737 / WD-73737 / WD-82737

WD-65837 / WD-73837 / WD-82837

OPTICAL ENGINE REPLACEMENT (Continued)

UPPER

DUCT

OPTICAL	C
ENGINE
	LOWER
	DUCT

Figure 4: Lower Duct Rear Mounting Screw

C

Figure 5: Lower Duct Front Mounting Screw

LOWER DUCT REMOVAL

1)Remove Upper Duct, Fans, Fan Holders, Thermal Sensor and Lamp Cartridge. See previous page.

2)Remove the 2 screws (C) one in front and one in the rear of the lower duct, refer to Figures 4 and 5.

3)Carefully remove the lower duct from the Engine.

ENGINE Replacement (Reverse the Removal Procedure)

1)Install Duct Assembly on the new Engine.

2)Remove the Protective Lens Cover from the face of the Lens and place it on the old Engine.

3)Install the Engine Assembly in the cabinet.

4)After a new Engine is installed, perform the “Restore Index Delay” and “Save Engine and Geometry Setting to Backup” procedures as described in the Data Transfer section of the Service Adjustments.

5)If needed. perform the Horizontal and Vertical Centering Adjustment and Manual Geometry Alignment described in Service Adjustments.

Page 13