Installation, Tools required | Jet Tools XACTA specification

Installation

Tools required

7/16" and 1/2" wrenches Cross point screwdriver 3/16" hex wrench Adjustable square Hammer (or rubber mallet) Straight edge

The following instructions are for installing the XACTA Fence II and Rail System on JET Models JTAS-10 and JTAS-12 series table saws. The Rails should bolt up to the JET saw without any drilling.

Figure 1

Front Rail Installation Referring to Figures 1 and 2:

1. Identify the front rail (E), which is 2-1/2" x 2-1/2" with notches on one side and countersunk mounting holes on the other side.

2.Lightly secure the front rail (E) to the table (G) and extension wings (F) with four 1/4 x 1-1/2 flat head screws (A) four 1/4” flat washers (B), four 1/4” lock washers (C) and four 1/4” hex nuts (D). Tighten just enough to hold the rail next to the table but keep loose enough to allow height adjustment.

Figure 2

The front rail must be 9/16" down from the table top in order to clear the miter gauge slot. This measurement is critical.

3.Place an adjustable square on the table as shown in Figure 3.

4.Check the height of the Front Rail at several locations along the surface of the saw table. The front rail must be parallel with the table top.

5.When the Front Rail has been correctly positioned, tighten all mounting screws securely with a #3 cross point screwdriver and

7/16" wrench.

Figure 3