Back Rail Installation

1.Locate the back rail which is 2" x 2" with holes running along one side only. The height of the back rail when attached to the saw is not critical.

2.Align the holes in the back rail to the holes in the table top, as shown in Figure 4.

Figure 4

3.Secure the back rail to the pre-tapped holes in the saw table (B, C, Fig. 4) with two 5/16 x 3/4 hex cap screws and two 5/16 flat washers, as shown in Figure 5. Tighten screws securely with a 1/2" wrench.

Figure 5

4.Secure the back rail at A and D (in Figure 4) to each extension wing with a 1/4 x 1-1/2 hex cap screw, two 1/4” flat washers, a 1/4” lock washer, and a 1/4” hex nut as shown in Figure 6.

5.Tighten nuts.

Figure 6

Important: If you are installing an optional wood extension table on your saw, it should be installed first before mounting the guide tube. This will prevent having to mount and align the guide tube twice.

If you are not mounting an optional wood table, proceed to Guide Tube section.