5.Open the valve on the hydraulic cylinder to allow the bow to descend in a gradual and controlled manner.
6.The machine will shut off at the completion of the cut. Remove the workpiece.
7.Close the hydraulic cylinder valve, and raise the bow in preparation for the next cut.
Maintenance
Before doing maintenance on the machine, disconnect it from the electrical supply by pulling out the plug or switching off the main switch. Failure to comply may cause serious injury.
Clean the machine of chips, shavings, etc. with a rag or brush. Do not use your hands.
If the power cord is worn, cut, or damaged in any way, have it replaced immediately.
The ball bearings on the blade guide assemblies are
Occasionally grease the lead screw on the vise.
19