Jet Tools HBS-56S operating instructions Assembly of Stand, Tools required for assembly

Page 8

Read and understand the entire contents of this manual before attempting set-up or operation! Failure to comply may cause serious injury.

Assembly of Stand

Tools required for assembly:

Two 1/2-inch wrench (Note: A ratchet wrench may speed assembly time.)

1.Assemble left (A) and right (B) side plates with six 5/16"x3/4" hex cap screws (C1), twelve 5/16” flat washers (D1) and six 5/16" hex nuts (E1). Tighten the hex nuts.

2.Turn the assembly (from Step 1) on its back (door opening up) and mount the bottom plate (F) with two 5/16"x3/4" hex cap screws (C2), four 5/16” flat washers (D2) and two 5/16" hex nuts (E2). Tighten the hex nuts.

3.Install the two rubber feet (G) on the bottom of the left plate (A).

4.Turn the assembly upside down and install the wheel base (H) with four 5/16"x3/4" hex cap screws (C2), eight 5/16” flat washers (D2) and four 5/16" hex nuts (E2).

5.Insert the axle (J) through the holes of the wheel base (H).

6.Install a wheel (K) and two 5/8”x30 flat washers (L) on each end of the axle. Insert cotter pins (M) through holes on each end of the axle and bend the ends of the cotter pins to secure the wheel on the axle.

7.Install the handle (N) to the left side plate (A) with four 5/16”x1-1/2” hex cap screws (O), four 5/16” flat washers (D4) and four 5/16" hex nuts (E4). Tighten the hex nuts.

8.Install the door (P). The upper hinge pin is spring loaded and must be retracted to mount the door to the cabinet.

9.Install the door lock knob.

Installation of the chip pan (R) is described in Mounting Band Saw to Stand on the following page.

Figure 1

8

Image 8
Contents 6-inch Horizontal Band Saw Warranty and Service More InformationTable of Contents Page Page Introduction Specifications HBS-56SShipping Contents Assembly of Stand Tools required for assemblyMounting Band Saw to Stand Assembly of Band SawPulley Cover and Belt Installation Grounding Instructions Stock StopVolt Operation Squaring Vise to Blade 90 Stop AdjustmentsExtension cords Positioning the Vise Setting 45 StopSetting Downfeed Rate Miter Cuts Blade Tracking Setting Blade SpeedBlade Tension Guide Bearings Blade Guide AssemblyBelt Tension Automatic Shut-Off Blade ReplacementSwitch Lock-Out Operation Vertical Bow PositionMaintenance Parts TroubleshootingReplacement Parts Parts List HBS-56S Band Saw Index No. Part No Description Size QtyTS-0050011 Index No Description Size Qty Parts List Bow AssemblyBow Assembly Page 2 Bow Assembly Page 3 Base and Cabinet Assembly Electrical Connections