WARNING
Use caution when lifting and stabilize until firmly attached to the
stand! Failure to comply may cause
serious injury!
4.Line up holes in saw body with holes in the top of the stand. Fasten saw body to the stand with four M8 x 40 hex cap screws, eight M8 washers, four M8 lock washers, and four M8 hex nuts (as shown in item A, page 10).
5.Push motor cord and strain relief plate through the opening in the side of the stand (Fig. 8). Fasten the strain relief plate to the stand with two M5 x 12 pan head machine screws (shown in item B, page 10).
6.Check the alignment of the pulleys by placing a straight edge against the flat sides of the motor and wheel pulleys (Fig. 8a). If the pulleys lie in a straight plane (Fig. 8b) they are aligned. If they do not lie in a straight plane, loosen the set screw on one of the pulleys and shift the pulley in or out until both pulleys lie in a straight plane. Tighten set screw.
7.Open the lower door, and place the
8.Loosen the nuts on the four motor mounting bolts (Fig. 8c) and tension the
down on the motor. Tighten the four motor mounting nuts.Saw body is heavy!
12