Jet Tools JWBS-14DX operating instructions

9.The v-belt is properly tensioned when finger pressure between the two pulleys causes approximately 1/2" deflection (fig. 8d).

10.Screw the two small knobs (Fig. 9) into the threaded holes in the saw body. Slide the pulley cover down over the knobs, and tighten the knobs.

11.Attach trunnion support to saw body with two M8 x 30 hex cap screws and two M8 lock washers (as in item D, page two). See Figure 12.

12.Thread nut on to table stop bolt (Fig. 12) and attach to trunnion support bracket as shown.

13