Control Panel JDP-20VS-1, Changing Spindle Speeds

ControlPanel- JDP-20VS-3

High-Low Switch (A, Fig. 5) - the center position is neutral. Turn to the right to select the low motor speed. Turn to the left to select the high motor speed.

Drill Tap Switch (8, Fig. 5) - the center position is the off position. Push the switch to the left for the

drill function. Push the switch the right for the tap function.

Power Indicating Lamp (C, Fig. 5) - indicates power to the main panel when lit. This lamp will only light up in the drill or tap mode.

Motor Start Button (D, Fig. 5) - activates the motor in the drill or tap mode.

Tap Return Button (E, Fig. 5) - reverses the spindle rotation and the tap withdraws. Works only in the tap mode.

Emergency Stop Button (F, Fig. 5) - disconnects

the power to the motor. Reset the button by turning 90°.

Control Panel - JDP-20VS-1

On-Off Switch - turns power to the machine on and off.

Changing Spindle Speeds

To change spindle speeds, turn the hand wheel (A, Fig. 6) until the pointer shows the desired speed. Speeds are approximate.

Adjusting the Depth Stop for Drilling

Adjust the zero reading on the scale by:

1.Lower the quill to the bottom of its stroke by turning the handle (A, Fig. 7) counter-clockwise until it stops and hold in that position.

2.Turn the knurled knob (8, Fig. 7) until the pointer

reads zero.

3.To set the depth stop, turn the knurled knob (8, Fig. 7) to the desired setting. The quill will now only advance to this setting.

Fig. 5

Fig. 6

BJf~

Fig. 7