ADJUSTING RAIL STOP
1.The Rail Stop Assembly Fig. 30, can be adjusted to any number of positions along the guide rail providing a quick stop setting for the Unifence body by loosening knob (G) and sliding the stop along the rail to the desired position and re- tighten.
2.Any number of stops can be purchased and installed to provide time saving quick stop adjustment for the Unifence body.
3.If flip stop does not retract fully the bolt (F) Fig. 30, may have to be repositioned in the rail slot to allow the flip stop to retract fully. If bolt (F) needs to be repositioned, just slide the bolt out of the rail and turn the head of the bolt one third of a turn (one flat) and slide back into rail, repeat this until the bolt is in the right position for the flip stop to retract fully. Fig. 31.
ASSEMBLING CURSOR TO UNIFENCE BODY
1.Remove two screws and flat washers (A) Fig. 32, and assemble the cursor (B) to the Unifence body (C). Replace the two screws and flat washers (A).
2.Fig. 33 illustrates the cursor (B) assembled to the Unifence body. Adjustment to the cursor (B) will be made later.
A
C
B
Fig. 32
P
R
Fig. 29
F
G
Fig. 30
Fig. 31
B
Fig. 33
10