Delta 36-841 instruction manual

ASSEMBLY INSTRUCTIONS FOR MODEL 36-918 52" UNIFENCE WITH 34-978 TABLE AND SHELF

Fig. 33

1.Fig. 33 shows the hole location for mounting the Unifence table legs to the table board.

2.Lay the table upside down on the floor or bench, as shown in Fig. 34.

3.Assemble the two table legs (A) Fig. 35 to the bottom of the table using eight #8x7/8" wood screws.

4.Assemble shelf support bracket (B) Fig. 36, to the table legs (A) using two U-clamps (C), flat washers, and hex nuts. NOTE: The shelf support bracket should be attached to the legs with the shelf support bracket facing the long end of the table board. NOTE: Height adjustments to the bracket will be made later.

5.Insert foot adapter (T) Fig. 37, into the bottom of each leg (A). Assemble the 3/8" jam nut (V) approximately 3/4 of the way onto leveling screw (W). Thread the leveling screw (W) into foot adapter. Fig. 38 illustrates the foot leveling assembly on the table leg. Assemble the remaining foot assembly to the other table leg in the same manner. NOTE: Height adjustments can be made later.

A

C

B

Fig. 36

Fig. 34

A

A

Fig. 35

Fig. 37

Fig. 38

14