A
C
B
Fig. 60
ASSEMBLING CURSOR TO UNIFENCE BODY
1.Remove two screws and flat washers (A) Fig. 60, and assemble the cursor (B) to the Unifence body (C). Replace the two screws and flat washers (A).
2.Fig. 61 illustrates the cursor (B) assembled to the Unifence body. Adjustment to the cursor (B) will be made later.
ASSEMBLING UNIFENCE BODY TO GUIDE RAIL
1.Turn fence body (A) Fig. 62, upside down and lay it on a table or bench. Rotate the handle (B) to the left till it stops in the positive indent. The clamp bracket (C) should be parallel to surface (D) of the fence body. Pull the handle (B) out till the clamp bracket (C) contacts surface
(F) of the fence body. If necessary pivot the clamp bracket till it is parallel to surface (F). Push the handle (B) back in, but do not rotate it.
2.Place fence body (A) Fig. 63, onto the guide rail as shown, making sure clamp bracket is inserted into channel (G) on rail. Notice that the clamp handle (B) is turned to the left indent position.
3.Make sure the handle (B) Fig. 64, is pushed in, then rotate the handle to the right to the positive indent. This will position the clamp bracket in the locking position, and prevent the fence clamp from sliding out of the channel (G).
4.Lock fence body (A) to the guide rail by pushing down on handle (B) as shown in Fig. 65.
ADJUSTING CLAMP HANDLE POSITIVE INDENTS
1.If the clamp handle is to tight or to loose when rotating to the left positive indent for fence removal, or to the right positive indent for fence locking and adjustment can be made.
2.Turn the fence body (A) Fig. 62, upside down and lay it on a table or bench. To make the indents feel more positive tighten the set screw (G), to make the indents less positive loosen the set screw (G).
B
Fig. 61
G E F
B
C
A
D
Fig. 62
A
G
G
B
Fig. 63
A
B
Fig. 65
B
G
Fig. 64
19