SPECIFIC SAFETY RULES
1.Maintain a safe working environment. Keep the work area well lit. Make sure there is adequate surrounding workspace. Always keep the work area free of obstructions, grease, oil, trash, and other debris. Do not use the Tile Saw in areas near flammable chemicals, dusts, and vapors.
2.Maintain labels and nameplates on the Tile Saw. These carry important infor- mation. If unreadable or missing, contact Harbor Freight Tools for a replacement.
3.Use the right product for the right job. There are certain applications for which this product was designed. Do not use small equipment, tools, or attachments to do the work of larger industrial equipment, tools, or attachments. Do not use this product for a purpose for which it was not intended.
4.This product must continuously run with cold water. Dry running will cause serious damage to the Pump seals.
5.
CAUTION! Keeps hands and fingers away from cutting area and Saw Blade. Use an appropriate “push stick” (not included) when necessary.
6.Check Blade Guard for proper upward/downward movement before each use. Do not operate the Tile Saw if the Blade Guard does not move freely. Never clamp or tie the Blade Guard into the upper position. If the Tile Saw is accidently dropped the Blade Guard may be bent. Raise the Blade Guard and make sure it moves freely and does not touch the Saw Blade or any other part of the Saw, in all angles and depths of cut.
7.Do not pull or carry the Tile Saw by its Power Cord or pull the Cord around sharp corners or edges. Do not unplug the Tile Saw by pulling on the Cord. Keep the Cord away from heated surfaces.
8.Keep all guards in place and in proper working order.
9.Do not handle the Power Switch with wet hands.
10.Make sure the Tile Saw is mounted on a flat, level, sturdy work surface capable of supporting the weight of the Saw and workpieces.
11.Always use Continuous Rim, Diamond Saw Blades with a 10” diameter, 5/8” round arbor hole, and rated at 3,500 RPM or greater. Saw Blades that do not match the mounting hardware of the Tile Saw or that are rated less than the required minimum RPM will run eccentrically causing loss of control or may fly off the Saw.
12.Use the Tile Saw only for cutting ceramic tile, quarry tile, marble, terra cotta, and slate with a maximum thickness of 3”.
SKU 91482 | For technical questions, please call | Page 8 |