Figure 2 – Dimension and Access Data
GENERAL SAFETY INFORMATION
WARNING: RISK OF ELECTRIC SHOCK
These serving instructions are for use by qualified personnel only, To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so.
1.Read this manual thoroughly before beginning the installation of this unit.
2.Conference to all local ordinances associated with building codes and electrical codes is required prior to beginning installation of this unit. Authorities having jurisdiction should be consulted before installation is made. If there are no local codes, the installation should conform to the National Electrical Code.
CAUTION:
The weight of the air cleaner is 150 lbs. Any mounting arrangement must be able to support this weight. Failure to determine if mounting is sufficient may result in damage or injury within the area.
INSTALLATION
Prior to beginning installation, select the location for the air cleaner. The air cleaner should be located as close to the contaminant source as possible. The air enters the air cleaner from the bottom (or specified side with inlet plenum as viewed from the access door side) and discharges vertically through the grille in the cabinet top panel. Do not obstruct the air flow from the unit. Maintain at least 18 inches (45 cm) clearance above the unit.
MOUNTING
WALL OR VERTICAL SUPPORT MOUNTED
1.Four (4) tapped holes are provided in the cabinet back. Bars may be mounted to the cabinet with existing hard ware. The MP600M can then be mounted to the wall or vertical support stand (not provided) with 3/8” hardware (not provided).
2.The inlet plenum is equipped with a ½” half coupling to connect drain piping. Plumbing should be routed to the collection point to facilitate drainage.
3.Affix duct(s) or elbow fitting(s) or flex hose(s) to the inlet plenum flange collar using hose clamps or other similar connection method. (Clamps, elbows and/or duct are not provided).
4
