Atech Tech SKAT-02 M, PEGASUS-02 M manual Operation, Adjusting the AIR Pressure of Pneumatic Clamps

7. OPERATION

The miter saws PEGASUS / SKAT cut non-ferrous aluminum, PVC profiles and PVC materials. The operator adjusts (manually via knob) the cutting speed of the saw blade according to the material type to be cut. Inner and outer sharp edges of the carbide tipped circular saw blade ensures high quality clean cutting results. The cutting length can be precisely read and adjusted using the measuring tape fixed to the back fence.

CAUTION !

Start the machine only after proper clamping of the work piece to be cut.

The machine is equipped with horizontal clamps. The clamping positions, either manual or pneumatic clamps, can be adjusted comfortably according to the material.

At manual clamps the clamp shaft can be moved 50 mm.

At pneumatic clamps the clamp piston can be moved 55 mm.

The clamping cylinders have to be outside of the saw blade moving area. (See Illustration 6 and 7)

IMPORTANT

The air pressure of the machine (pneumatic model) has to balance 6-8 Bar (90-120 psi) pressure. Don’t operate the machine with an air pressure lower than 6 Bar.

7.1.ADJUSTING THE AIR PRESSURE OF PNEUMATIC CLAMPS

7.1.1.Pull the adjustment button of the conditioner upwards.

a- Turning the adjustment button in clockwise direction increases the pressure

b- Turning the adjustment button in counter clockwise direction decreases the pressure c- Once you read 6-8 Bar (90-120 psi)on the manometer, push the adjustment button of the conditioner down and lock it in that position.

16

Operating and Safety Instructions