Pressure
Adjustment
Button
Manometer
Air Pressure and
Water Discharge
Screw
Illustration 3
Oil Depot
Oil Filling Tap
7.1.1.Place the material to be cut on the machine table, take the measure the cutting length using the measuring tape on the back fence, and clamp the work piece (pneumatically or manually).
7.1.2.Start to operate the saw blade by pressing the Start button.
7.1.4.Carry out the cutting operation by pressing down the cutting head holding the grip.
7.1.5.After cutting off the material, bring the cutting grip to its original position, press the Stop button. The saw blade will come to a full stop within 15 sec.
7.1.6.Release the clamps (manually or pneumatically) and take out the cut work piece.
7.1.7.The conditioner unit collects the water within the air system in a receptacle in order to prevent damage to the pneumatic system components. Discharge this water periodically (at the end of the working day) by pressing or opening the button under the conditioner.
7.1.7.The manufacturer recommends to use the following oils with the conditioner: TELLUS C 10 / BP ENERGOL HLP 10/ MOBIL DTE LIGHT / PETROL OFISI SPINDURA 10.
Don’t operate the saw while it touches the work piece. The saw must be operated only when the head is in the top position.
17