Atlas LS 14, LS 16 manual Problem Cause Solution

7 English

"￿$1￿!￿￿￿￿￿ ￿￿*￿

WARNING

Maintenance must be done only by suitably qualified and competent persons.

Problem	Cause	Solution
Cut-off Saw turns too fast or	Connected to improper	Use proper power supply
develops too much torque	power source
	Power source out of	Adjust power source flow
	adjustment	and pressure settings as per
		the manufacturer’s
		instructions
Cut-off Saw will not turn at	Power supply defect	Disconnect Cut-off Saw and
all or turns too slowly		check power supply
	Valve/valve block defect	Repair or replace
	Motor defect	Disconnect power source
		and try to turn the motor
		shaft by hand. Repair or
		replace
Cut-off Saw does not	Power supply defect	Repair or replace
develop enough torque
(insufficient power to cut	Motor defect	Repair or replace
material)