Chicago Electric 91511 Assembly Instructions, Assembly Diagram on, See Figure D, next

25. WARNING! People with pacemakers should consult their physician(s) before using this product. Electromagnetic fields in close proximity to a heart pacemaker could cause interference to or failure of the pacemaker.

26.WARNING! Some dust created by power sanding, sawing, grinding, drilling, and other construction activities, contain chemicals known (to the State of California) to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement or other masonry products, arsenic and chromium from chemically treated lumber. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. (California Health & Safety Code 25249.5, et seq.)

27.The warnings, precautions, and instructions discussed in this manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

ASSEMBLY INSTRUCTIONS

NOTE: For additional references to the parts listed in the following pages, refer to the

Assembly Diagram on page 17.

To Remove And Install The Saw Blade:

1.WARNING! Prior to performing any assembly procedures, make sure the Power Cord (17) of the Wet Tile Saw is unplugged from its electrical outlet. Also, make sure the unit has completely cooled and wear heavy duty work gloves.

2.Open the Left Side Cutting Table (26) to expose the old Saw Blade (6).

(See Figure D, next page.)

3.Using the accessory Wrench (33), remove the Blade Lock Nut (27) by unscrewing it in a clockwise direction. (See Figure D.)

4.Once the Blade Lock Nut (27) is removed, remove the Outer Washer (28).

(See Figure D.)

5.While wearing heavy duty work gloves to avoid accidental cuts, remove the old