RIGHT CUTTING TABLE
(10)
FIGURE H
WORKPIECE
(NOT INCLUDED)
STAND
POWER SWITCH (21)
(0° to 60°) and tighten the Lock Knob to lock the Miter Guide in place.
(See Figure I.)
3.Place the workpiece flush against the Miter Guide (24). Turn the Power Switch
(21)toits “ON” position, and allow the Saw Blade (6) to spin up to full speed. Then, slowly and carefully push the workpiece into the Saw Blade until the cut is completed. (See Figure I.)
4.Once the cut is completed turn the Power Switch (21) to its “OFF” position, and allow the Saw Blade (6) to come to a complete stop on its own. Then remove the workpiece, and unplug the Power Cord (17) from its electrical outlet.
(See Figure I.)
WORKPIECE
(NOT INCLUDED)
MITER GUIDE
(24)
POWER SWITCH 
(21)
FIGURE I
SKU 91511 | PAGE 15 |