FILL RESERVOIR WITH WATER
LEFT CUTTING TABLETO LEVEL OF
FIGURE F
3.Make sure the Power Switch (21) is in its “OFF” position. Then, plug the Power Cord (17) into the nearest 120 volt, grounded, electrical outlet. (See Figure G.)
To Perform Straight Cutting:
1.Lift the front and rear Levers of the Fence (11). Slide the Fence along the Table to the left or right until the desired width of cut is aquired as indicated on the Fence Scale. Then, lower the front and rear Levers of the Fence to lock the Fence in place. (See Figure G, next page.)
2.Place the workpiece flush against the Fence (11). Turn the Power Switch (21) to its “ON” position, and allow the Saw Blade (6) to spin up to full speed. Then, slowly and carefully push the workpiece into the Saw Blade until the cut is com- pleted. (See Figure G.)
3.Once the cut is completed turn the Power Switch (21) to its “OFF” position, and allow the Saw Blade (6) to come to a complete stop on its own. Then remove the workpiece, and unplug the Power Cord (17) from its electrical outlet.
(See Figure G.)
To Perform Angle Cutting:
1.Make sure the Power Switch (21) is in its “OFF” position. Then, plug the Power Cord (17) into the nearest 120 volt, grounded, electrical outlet.
(See Figure H, page 15.)
SKU 91511 | PAGE 13 |