SPECIFIC SAFETY RULES
1.Maintain labels and nameplates on the Wet Tile Saw. These carry important information. If unreadable or missing, contact Harbor Freight Tools for a replace- ment.
2.DANGER! Keep hands and fingers away from cutting area and Saw Blade. Use a appropriate push stick (not included) whenever possible.
3.Check Blade Guard for proper upward/downward movement before each use. Do not operate the Wet Tile Saw if the Blade Guard does not move freely. Never clamp or tie the Blade Guard into the upward position. If the Wet Tile Saw is accidentally dropped, the Blade Guard may be bent. Raise the Blade Guard and make sure it moves freely and does not touch the Saw Blade or any other part of the Saw, in all angles and depths of cut.
4.Always use Diamond Blades with a 7” diameter, 5/8” round arbor hole, and rated at a minimum 3,600 RPM. Blades that do not match the mounting hardware of the Wet Tile Saw or that are rated at less than the required minimum RPM will run eccentrically causing loss of control or may fly off the Saw.
5.Use the Wet Tile Saw only for cutting ceramic tile, quarry tile, marble, terra cotta, and slate with a maximum thickness of
6.Do not use the Wet Tile Saw for cutting metals, or for cutting curves. This may cause the Saw Blade to break, and reduce its service life.
7.Make sure the Saw Blade remains wet at all times while cutting.
8.Always keep the water level at the recommended level
9.Avoid splashing water on the Motor, Power Switch, or any electrical compo- nent. Make sure to stand on a dry, insulated surface, such as a rubber mat, while using this Wet Tile Saw.
10.Make sure to clean the water reservoir thoroughly after each use.
11.Never use damaged or incorrect Saw Blade washers or nuts. The Saw Blade’s washers and nut were specially designed for your Saw, for optimum performance and safety of operation.
12.To avoid accidental injury, always wear heavy duty work gloves and long sleeved work shirt when changing a Saw Blade.
SKU 91511 | PAGE 8 | 07j |