WORKPIECE | FENCE |
(NOT INCLUDED) | (11) |
FENCE LEVER
FENCE SCALE
FENCE |
| LEVER | POWER SWITCH |
| |||
FIGURE G | (21) | ||
2.Raise the Right Cutting Table (10) to the desired angle of cut (i.e., 15,o30,o45,oor 60o ). (See Figure next page.)
3.Place the two Stands underneath the Right Cutting Table (10) into the grooves to hold the Cutting Table in position. (See Figure H.)
4.Place the workpiece finished side down onto the Right Cutting Table (10).
(See Figure H.)
5.Turn the Power Switch (21) to its “ON” position, and allow the Saw Blade (6) to spin up to full speed. Then, slowly and carefully push the workpiece into the Saw Blade until the cut is completed. (See Figure H.)
6.Once the cut is completed turn the Power Switch (21) to its “OFF” position, and allow the Saw Blade (6) to come to a complete stop on its own. Then remove the workpiece, and unplug the Power Cord (17) from its electrical outlet.
(See Figure H.)
To Perform Miter Cutting:
1.Make sure the Power Switch (21) is in its “OFF” position. Then, plug the Power Cord (17) into the nearest 120 volt, grounded, electrical outlet.
(See Figure I, next page.)
2.Loosen the Lock Knob on the Miter Guide (24). Then select the degree of cut
SKU 91511 | PAGE 14 |