STOP BLOCK
See Figures 5 and 6.
The stop block is useful as a stop for cutting multiple pieces to the same length. It can be installed on either table extension on either side of the saw base:
•Slide the stop block on the back arm of either table extension, then insert the table extension into the saw base. See Figure 5.
•Use the small wing screw to secure the stop block to the table extension. See Figure 5.
•Loosen the small wing screw and adjust the stop block the desired distance from the blade for the cut to be made.
•Tighten small wing screw securely,
•Make a test cut in scrap material and measure the length of the workpiece.
•Make any necessary adjustments.
_, WARNING: When using the work clamp with the stop block, install the clamp o_ the stop block side of the blade. This will eliminate the
possibility of the saw catching the loose end and kicking up. Failure to heed this warning can result in serious personal injury.
STOP
BLOCK
STOPBLOCK
SMALL
WINGSCREW
MITERSAWBASE
Fig. 6
EXTENSION | Fig. 5 |