Dell UCP-61, UCC-60, UCP-60 manual Post Error Messages, 111

Models: UCP-61 UCP-60 UCC-60

1 156
Download 156 pages 12.96 Kb
Page 111
Image 111

Troubleshooting

To get help with your Dell™ PowerEdge™ Expandable RAID Controller (PERC) 6 and Dell Cost-Effective RAID Controller (CERC) 6/i controller, you can contact your Dell Technical Service representative or access the Dell Support website at support.dell.com.

Post Error Messages

The controller BIOS read-only memory, ROM provides INT 13h functionality (disk I/O) for the virtual disks connected to the controller, so that you can boot from or access the physical disks without the need of a driver. Table 7-1 describes the error messages and warning messages that display for the BIOS. Table 7-2 describes the error messages that display for displays the battery backup unit (BBU).

Table 7-1. BIOS Errors and Warnings

Message

Meaning

BIOS Disabled. No Logical This warning message displays after you disable Drives Handled by BIOS the ROM option in the configuration utility.

When the ROM option is disabled, the BIOS cannot boot Int13h and cannot provide the ability to boot from the virtual disk.

 

Int13h is an interrupt signal that supports

 

numerous commands that are sent to the

 

BIOS, then passed to the physical disk. The

 

commands include actions you can perform

 

with a physical disk, such as reading, writing,

 

and formatting.

 

 

Press <Ctrl><R> to

When the BIOS is disabled, you are given the

Enable BIOS

option to enable it by entering the

 

configuration utility. You can change the setting

 

to Enabled in the configuration utility.

Troubleshooting

111

Page 111
Image 111
Dell UCP-61, UCC-60, UCP-60 manual Post Error Messages, 111