•When making a cut use steady, even pressure. Never force cuts.
•Do not cut warped or wet lumber.
•Always hold your saw firmly with both hands and
keep your body in a balanced position so as to resist the forces of kickback should it occur.
When using your saw, always stay alert and exercise control. Do not remove your saw from workpiece while the blade Is moving.
DEPTH OF CUT ADJUSTMENT
Always keep correct blade depth setting. The correct blade depth setting for all cuts should not exceed 1/4 inch below the material to be cut. More blade depth will increase the chance of kickback and cause the cut
to be rough. One blade tooth below the material to be cut works best for most efficient cutting action.
TO ADJUST BLADE DEPTH
•Remove battery pack from saw.
STARTING A CUT
Know the right way to use your saw.
See Figure 12.
RIGHT | Fig. 12 |
,_ WARNING: Failure to remove battery pack from saw could result in accidental starting causing possible serious personal injury.
Never use your saw as shown in figure 13.
_"
| DEPTH |
|
BASE | ADJUSTMENT |
|
ASSEMBLY | KNOB | Fig. 11 |
•Loosen depth adjustment knob. See Figure 11.
•Hold base flat against the workpiece and raise or lower saw*until the required depth is reached.
•Tighten depth adjustment knob securely.
WRONG
Fig. 13
Never place your hand on the workpece behind your saw while making a cut.
_i_ WARNING: To make sawing easier and safer, always maintain proper control of your saw. Loss of control of your saw could cause an accident resulting in possible serious injury.
13