Assembling the Spray Wand
Wand | Screw | Trigger |
| Cap | Valve |
Push the wand into the trigger valve and secure with screw cap. Hand tighten to prevent leakage.
CAUTION!
Do not overtighten!
Adjusting the Shoulder Straps
Changing Lever Operating Side
NOTE:
The operating lever may be mounted on the left or right side of the sprayer tank depending on operator preference.
Connecting
Rod
Pump
Chamber
Tightening
1.Place the sprayer on your back with the staps loosened.
2.Hold the adjustment ring firmly and pull until backpack is secure in place.
Buckle
Adjustment 
Ring
| Nut | |
| Retainer | |
Pump Lever | Pump | |
Lever | ||
Shaft | ||
| ||
| Washer | |
| Bolt |
Loosening
Lift up on the buckle to release tension.
IMPORTANT!
After assembling the sprayer, fill the tank with clear water and lay it on its side. Check for leaks. Return sprayer to its upright position. Pump the lever
Most leaks can be stopped by tightening the appropriate connection or fitting. Any leaks must be stopped prior to filling the sprayer with chemicals.
WARNING!
Remove all chemicals and wash the sprayer thoroughly before beginning to change the lever operating side.
1.Loosen the pump lever bolt and slide pump lever off of the pump shaft linkage.
2.Move the pump lever to the opposite side of the sprayer tank and install onto the pump lever shaft linkage as shown.
IMPORTANT!
Make sure that the pump lever is installed so that full up and down movement of the pump chamber is available.
3. Tighten pump lever bolt securely.
3