Norton Abrasives C9 owner manual Preparation, Assembly

Page 7

I.PREPARATION

B.Assembly

The compact concrete saws are shipped completely assembled and ready for use except for diamond blade, gasoline, oil, and handle bar. Inspect the saw for shipping damage. If any damage is found, contact the shipper immediately and file a freight claim. The Norton Company is not responsible for any freight-related damages. Remove the saw from the pallet. Reverse the position of the handlebars so that the handle bar sticks out towards the operator. Adjust the handlebars to the desired height. Attach the handlebars to the saw with the supplied hardware. Read and understand the remaining sections of this Owners Manual. NOTE: Do not install the blade until it is time to use the saw. ANSI regulations prohibit the transportation of any concrete saw with the blade installed.

7

Image 7
Contents Small Concrete Saw Warranty Use Only Clipper Diamond Blades Hazard Symbols Safety PrecautionsPreparation Dust and Silica Warning You Are Responsible For Your Safety Assembly Engine C9 Series Concrete Saw SpecificationsDimensions/Weight CharacteristicsPointer Alignment Installing the BladeII. Operation EngineWater Supply Starting the EngineOperating the Saw Additional Guide Lines For Sawing Cutting TechniqueIII. Maintenance Bearings Dry Cutting Engine MaintenanceRemember, too much tension shortens belt Bearing life BeltsDepth Control Ordering Information IV. Parts List SectionDescription Part Number C9 Parts Drawing C9 Parts Drawing Service Parts List C9 Page PO Box Gainesville, GA Norton Construction Products