DESCRIPTION OF THE MACHINE AND ITS OPERATION.
MACHINE MODEL
The machine consists of a metallic stand with a wood base on which the machine is mounted. The pedal and the electronic equipment that control the machine are located in the stand.
The head of the machine is comprised of a machine housing and two raceways (one on each side). The moving parts in the machine are located inside the housing, such as: the main motor, axles, eccentrics, bearings, etc. The grommets and the washers use the two raceways to descend.
The
Both hopper boxes are rotated by individual 24V motors. The grommets that descend along the left raceway “ A2 ” are held by a small finger, which stops them from falling.
Lower horizontal guides hold the washers descending along the right raceway “ B2 ”.
The machine is controlled by an electronic unit designated IMO V3 “ C ”, located inside the mounting stand. The IMO V3 unit receives an electric signal through pedal “ D ” that allows the main motor “ E ”located behind the head, to quickly rotate and haul the
flywheel (part no. 274) with a belt making a 360° rotation causing the motor to stop sharply.
The flywheel (part no. 274) has a main shaft (part no. 207) that joins the plunger with the other moving parts. By rotating 360°, it exerts pressure on the driving stem and therefore the grommeting action is completed.
The top set spindle (part no. 218) inside the top set (part no.217) inserts itself inside the grommet and pulls it down from raceway “ A2 ”. At the same time the slide (part no. 297) pushes the washer from the slide track and places it exactly on top of the bottom set (part no. 219).
A1
A2
E
B1
B2
C
D