Sinclair PG-21 manual Machine Description

Page 6

Machine Description

Maximum interior diameter of grommet and washer is 12mm.

The machine perforates and sets the grommet with the washer at the same time.

Each set of dies sets only one grommet and washer model; the grommet models may differ in: the head size “B”, the length “C”, the interior diameter of tube “A”, the thickness, etc; and the washer models may differ in: the exterior diameter “B”, the length , the interior diameter of washer hole “A”, the washer shape, etc.

SINCLAIR EQUIPMENT RECOMMENDS YOU TO USE ALWAYS THE SAME TYPE OF GROMMET AND WASHER FOR WHICH THE MACHINE WAS DESIGNED. In order for the machine to set different grommet and washer models, certain parts need to be changed.

Sinclair Equipment will accept no responsibility arising from the use of this machine in any way different from that which is described in this instruction manual.

Grommet

Grommet Measurements

Washer Measurements

8mm Plastic Grommet

A: 8mm

No washer is used for

 

B: 15mm

8mm grommet.

 

C: 8mm

 

 

 

 

12mm Plastic Grommet

A: 12mm

A: 15mm

 

B: 26mm

B: 24mm

 

C: 8.3mm

 

6

Image 6
Contents Model PG-21 Identification of the Machine Description of the Machine and ITS Operation Remember the Machine Must not be Overturned Before Starting the MACHINE, Read These Warnings Carefully Machine Description Setting UP the Machine for ITS Operation Changing the top-set spindle #218 and the top die #217 Page Ring Guard Adjustments 238 217 219 194 230 306 260 Maintenance Troubleshooting Problem Cause Solution Schematic # Part# Description Schematic # Part# Description Schematic # Part# Description Schematic # Part# Description Schematic # Part# Description Tools And Parts