Harbor Freight Tools 94573 Assembly and Operating Instructions, Nozzle Selection And Assembly

ASSEMBLY AND OPERATING

INSTRUCTIONS

CAUTION! Wear eye, breathing, and skin protection. Wear ANSI-approved safety impact goggles, a NIOSH-approved respirator, latex gloves, and proper safety clothing when using this product.

Nozzle Selection And Assembly:

1.The Sprayer is equipped with the following Nozzle types:

FOUR HOLE

ADJUSTABLE

NOZZLE (62)

FIGURE H

c.Four Hole Adjustable Nozzle (62): Designed for spraying high crops and fruit trees and the spraying of pesticides. However, the Adjustable

Nozzle may result in significant overspray of pesticides.

(See Figure H.)

30° DUAL NOZZLE

(60)

FIGURE F

a. 30° Dual Nozzle (60): Designed for wider spray areas on short crops and the spraying of herbicides and pesticides. Follow the wind and move in a parallel manner on one side while spraying. (See Figure F.)

MIST

NOZZLE

(61)

FIGURE G

b. Mist Nozzle (61): Designed for narrow spray areas on low crops and the spraying of herbicides and pesticides. Follow the wind and move in a parallel manner on one side while spraying.

(See Figure G.)

CONICAL MIST

NOZZLE (65)

FIGURE I

d. Conical Mist Nozzle (65): Designed for spraying low crops and the spraying of herbicides and pesticides. Allows for a conical spray pattern. Follow the wind and move in a parallel manner on one side while spraying. (See Figure I.)

NOZZLE

(60, 61, 62, 65) NOZZLE NUT (1)

2.To attach a Nozzle (60, 61, 62, 65) to the Spray Gun, check to make sure the Nozzle Gasket Ring (4) is properly seated in the Nozzle Nut (1). Then, screw the desired Nozzle into the Nozzle Nut. (See Figure J.)