Harbor Freight Tools 94573 To Fill The Tank, To Operate The Sprayer, See Figures E and L

To Fill The Tank:

TANK

CAP (41)

TANK

FILTER (42)

TANK

(64)

FIGURE K

1.Prior to filling the Tank (64) of the

Sprayer with liquid, remove the Tank Cap (41) and check to make sure the Tank Filter (42) is clear of dirt and debris. If necessary, remove the Filter and thoroughly clean. (See Figure K.)

2.Next, insert the Tank Filter back into the opening of the Tank.

3.Fill the Tank with up to 4.8 gallons of liquid. Then, replace the Tank Cap on the Tank.

To Operate The Sprayer:

CAUTION! Make sure other adults, children, and animals do not have access to the spray area(s).

NOTE: The Sprayer is heavy when completely filled with liquid. Strap the Sprayer on with assistance. Adjust the Back Strap (45) as needed.

TRIGGER

(17)

TRIGGER

LOCK (16)

SPRAY

ROD (9)HANDLE (21)

FIGURE L

1.Grip the Handle (21) of the Spray Gun

Assembly firmly. Then, turn the Power

Switch (58) to its “ON” position.

(See Figures E and L.)

2.Point the Nozzle (60, 61, 62) of the Spray Gun Assembly toward the area to

be sprayed. Then, squeeze the Trigger to begin spraying. (See Figure L.)

NOTE: The Trigger (17) of the Spray Gun Assembly may be locked in a continuous run position with the Trigger Lock

(16). To do so, move the Trigger Lock backward toward the Handle (21). To return to manual operation, move the Trigger Lock forward toward the Spray Rod (9). (See Figure L.)

3.As you spray, the system will begin to depressurize. When the distance of the spray diminishes you will need to stop spraying momentarily. Allow the Sprayer to re-pressurize its system before spraying again.

4.If it becomes necessary to refill the

Tank (64) of the Sprayer, turn the Power Switch (58) to its “OFF” position. Continue squeezing the Trigger (17) on the Spray Gun Assembly to completely de-pressurize the system. Remove the Tank Cap (41) from the Tank. Check to make sure the Tank Filter (42) is clear of dirt and debris. Refill the Tank with liquid, and replace the Tank Cap. Turn the Power Switch to its “ON” position to pressurize the system, and continue spraying. (See Figures E and K.)

5.When finished spraying, turn the Power

Switch (58) to its “OFF” position. Continue squeezing the Trigger (17) on the Spray Gun Assembly to completely depressurize the system. Remove the Tank Cap (41) from the Tank (64), and empty any remaining liquid into a safe and secure container. Clean the Sprayer thoroughly with agents recommended by the chemical manufacturer. Allow the unit to air-dry. Replace the Tank Cap (41), and store the Sprayer in a clean, dry, safe location out of reach of children and other unauthorized people.

Page 8 For technical questions, please call 1-800-444-3353. SKU 94573