Selector Switch Knob
Selector Switch Knob
Use Knob Repair Kit 288756.
Disassembly
1.Turn selector switch knob clockwise as far as it will go.
Assembly
1.Position new knob to point right (approximately 45° from vertical) and slide it onto exposed spline.
ti9219a
2. Use wrench to remove nut from knob.
ti9278a
3. Pull knob straight off from sprayer.
ti9277a
Once knob has been removed, don’t move the exposed spline. If it is moved, use your fingers to turn it clockwise as far as it will go for a tight fit prior to reassembly of knob. This will properly align knob to spline.
ti9280a
2.Apply Locktite (1 drop or small amount) to knob nut and tighten with wrench.
ti9281a
311772G | 23 |