TROUBLESHOOTING
PROBLEm | cAuSE | AcTION REQuIRED |
|
|
|
Paint Sprayer hums but | Piston sticking (3c) | Remove the large knob at the top of the unit. Pull Nozzle |
does not operate |
| and Piston Assembly down and back to release from main |
|
| gun assembly. Insert the metal punch (7), supplied in the |
|
| spares pack, into the front of the cylinder housing and |
|
| gently tap the punch to eject the seized piston. Clean and |
|
| lubricate piston and cylinder. |
|
| reverse order. Remember to replace the compression |
|
| spring onto the piston before fitting the piston. Ensure you |
|
| have not dropped any parts into main Paint Sprayer |
|
| assembly. |
|
|
|
No suction feed | Liquid too thick | Thin liquid as recommended or contact paint manufacturer |
| No Valve Assembly | Remove Nozzle, and insert Valve Assembly and refit |
| (3a) | Nozzle |
|
| |
| Paint Suction Tube | Clean filter |
| and Filter Assembly |
|
| (4) blocked |
|
|
|
|
Paint Sprayer motor | Nozzle blocked part | Clean thoroughly with thinners or if water based paint, |
operates, but nothing | (1/2) | clean with water. |
comes out | Nozzle Valve | Clean thoroughly with thinners. |
| Assembly blocked |
|
| (3a) |
|
|
|
|
Paint Sprayer motor | Paint Container | Refill Paint Container |
operates but spluttering | almost empty |
|
| Paint Sprayer held at | Hold at correct angle |
| wrong angle | Thin liquid as recommended |
| Liquid too thick | |
|
| |
| Incorrectly set | Adjust regulator at back of Paint Sprayer |
| regulation control |
|
| Incorrect Nozzle | Replace Nozzle with other size |
| fitted |
|
| Worn Nozzle (1/2) | Replace Nozzle |
| Worn Valve |
|
| Assembly (3a) | Replace Valve Assembly |
|
|
|
Paint dripping from | Nozzle loose | Tighten Nozzle |
Nozzle |
|
|
| Paint Sprayer held | Keep Paint Sprayer upright |
| at more than 45˚ |
|
|
|
|
Excessive overspray | Pressure too high | Turn output knob clockwise to reduce pressure. |
| Holding Paint | Hold Paint Sprayer about |
| Sprayer too far from |
|
| surface |
|
|
|
|
Runs and sags in paint | Arm movement too | See section on spraying. (See page 6 and 7). |
| slow |
|
| Paint Sprayer too |
|
| close to work surface |
|
| Applying too much |
|
| paint in one go |
|
|
|
|
10