Belt
Belt
Disassembly
1.Relieve Pressure, page 6.
2.Unplug sprayer from outlet.
ti2810b
3.Remove Shroud, page 7.
4.Remove Motor, page 10.
5.Place motor tray (32) into vice and tighten until snug.
32
ti9063a
6.Use 9/16 in. wrench to loosen two mounting screws
(4) on motor tray (32) to allow motor to slide around.
ti9069a
ti9066a
7. Remove old belt and discard.
Reassembly
1.Loop one end of belt over extension cable (29) and pulley (17), then loop other end of belt over motor shaft (make sure teeth of belt (24) and pulley are aligned).
24
ti8784a
2.Insert flat screwdriver into slot on back of motor tray
(32)and use screwdriver as a lever to pull motor
(31)into position.
3.Use 9/16 in. wrench to tighten two mounting screws
(4)while keeping motor (31) in position with screw- driver.
ti9073a
Once the motor is in place, you can test the belt to 
make sure it is properly tightened. When you push on the belt (24) with one finger it should move no more than 1/4 in. If it moves more than 1/4 in., go
back to step 8 and
24
ti9071a
4.Reassemble Motor, page 10.
5.Reassemble Shroud, page 7.
311771D | 13 |