Troubleshooting
Problem | Cause | Solution | |
|
|
| |
|
|
| |
Speed of application too slow | New pump hose not broken in | Run pump dry for no longer than 2 | |
| properly | minutes. | |
|
|
| |
| Material too thick | Thin material. | |
|
|
| |
| Nozzle too small | Change nozzles to a larger size. See | |
|
| Operation Manual, Recommended | |
|
| Nozzle Selection Chart, page 10. | |
|
|
| |
| Plugged or dirty gun | Relieve Pressure, page 6. Clean | |
|
| gun. | |
|
|
| |
| Kinked hose | Unkink hose. | |
|
|
| |
| Gun fluid flow adjustment set too low | Increase flow adjustment with flow | |
|
| adjustment nut. | |
|
|
| |
Intermittent flow/sputtering | Hopper connection not tight | Check gasket. TIghten connection. | |
|
|
| |
| Debris in system | Clean system. | |
|
|
| |
Gun will not shut off | Worn nozzle or needle. | Relieve Pressure, page 6. Replace | |
|
| worn parts. | |
|
|
| |
| Debris in needle passage | Relieve Pressure, page 6. Clean. | |
|
|
| |
Fluid leaking at Flow Adjustment Nut | Damaged seal. | Relieve Pressure, page 6. Replace | |
on gun |
| seal. | |
|
|
| |
Fluid leaking out of either plug on gun | Missing or damaged | Relieve Pressure, page 6. Replace | |
|
| ||
|
|
| |
| Gun damaged | Replace gun. | |
|
|
| |
Needle adjustment on gun won’t | Dirty threads | Clean threads. | |
adjust |
|
| |
Nozzle not on gun | Put nozzle on gun. | ||
| |||
|
|
|
311771D | 15 |