RotoFlex™ II Pump
Reassembly
1.Bend hose (23) so colored dots on hose fittings face each other and slide hose fittings through hose bracket (27).
ti3084a
CAUTION
Make sure protective fabric faces outside of hose. Roller will touch exposed area of pump hose when pump is in place.
2.Squeeze hose ends together to keep hose (23) and bracket (27) together and feed pump hose fittings through holes on front of base.
27
23
ti8780a
3.Use 3/8 in. socket to tighten screw (36) on hose bracket (27).
4.Install hopper and tighten hopper fitting on hopper
(1) by hand until snug.
5.To set pressure, apply petroleum jelly to threads (41), tighten knob (41) until back of bracket (25) is approximately 1/2 in. from front of tensioning bracket (16).
25
16
ti9710a
Tighten front spacer (56) until flush to front of ten- sioning bracket (16). Tighten back spacer (56) 3/8 in. from tensioning bracket.
25
16
ti9656a
41
To break in new pump, run sprayer dry for no longer 
than two minutes.
Replace hose when mud seeps through slots in the 
base and leaves material on the floor.
ti8787a
311771D | 9 |