Warnings
CAUTION
•Water or material remaining in unit when temperatures are below freezing can damage motor and/or delay pump startup. Do not allow unit to freeze.
•Before adding material or starting unit in cold weather, run warm water through pump.
To ensure water and material are completely drained out of unit:
ti9016a 1. Remove material line from sprayer.
2. Tip sprayer up as shown.
Before adding material to the hopper, install the burp guard. When only a small amount of material remains in the hopper, the burp guard prevents material from shooting out when the unit is turned off. This material could splash in the operator’s eyes or on skin, or into the air.
ti9010a
4