Touch Up Hopper Attachment

Setup

9. Turn power switch ON.

ti9222a

10. Close gun air valve.

ti8712a

11.Point gun into waste bucket and pull trigger to pump water through the system. Continue to trigger gun until material hopper is empty.

ti9084a

12.Add pre-mixed texture mix to material hopper. See Mixing Material, page 10.

13.Continue to trigger gun and spray into waste bucket until a steady stream of material sprays out of gun.

14.Release trigger. To achieve uniform spray pattern, adjust air valve and flow adjustment nut on gun. If you do not achieve the desired pattern, change noz- zles, page 11.

ti8532a

Fluid flow will be restricted if the material hose is kinked.

CAUTION

Failure to change selector switch to Hopper Gun when using hopper gun will damage pump hose.

The Hose Plug must be securely fastened to bottom of gun when using the Touch Up Hopper. Gun plug must be removed from top of gun.

ti8701a

1.Connect air hose to sprayer.

2.Connect air hose to gun.

ti8534a

3.Slide hopper on top of gun, and tighten clamp.

4.Install spray nozzle. Page 11.

ti8535a

5.Fill Touch-up hopper with pre-mixed texture. See Mixing Material, page 10.

ti2559a