Graco 238377, 24G980 Fire and Explosion Hazard, Skin Injection Hazard, Treatment

Page 2

Warnings

Warnings

The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama- tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this manual where applicable.

WARNING

+

FIRE AND EXPLOSION HAZARD

Flammable fumes, such as solvent and paint fumes, in work area can ignite or explode. To help prevent fire and explosion:

Do not spray flammable or combustible materials near an open flame or sources of ignition such as cigarettes, motors, and electrical equipment.

Paint or solvent flowing through the equipment is able to result in static electricity. Static electricity creates a risk of fire or explosion in the presence of paint or solvent fumes. All parts of the spray system, including the pump, hose assembly, spray gun, and objects in and around the spray area shall be properly grounded to protect against static discharge and sparks. Use Graco conductive or grounded high-pressure airless paint sprayer hoses.

Do not clean with materials having flash points lower than 70° F (21° C). Use water-based material or mineral spirits-type material only. For complete information about your fluid, request the MSDS from the fluid distributor or retailer.

Verify that all containers and collection systems are grounded to prevent static discharge.

SKIN INJECTION HAZARD

High-pressure fluid from dispensing device, hose leaks, or ruptured components will pierce skin. This may look like just a cut, but it is a serious injury that can result in amputation. Get immediate surgical

treatment.

Do not point dispensing device at anyone or at any part of the body.

Do not put your hand over the fluid outlet.

Do not stop or deflect leaks with your hand, body, glove, or rag.

Follow the Pressure Relief Procedure when you stop dispensing and before cleaning, checking, or servicing equipment.

Tighten all fluid connections before operating the equipment.

Check hoses and couplings daily. Replace worn or damaged parts immediately.

2

308613E

Image 2
Contents RoadLazer RoadPak Line Striping System 308613ESingle Acting and Double Acting Paint Spray Guns for 238377 24G980Treatment Fire and Explosion HazardSkin Injection Hazard Equipment Misuse Hazard Toxic Fluid or Fumes HazardMount Valve InstallationConnect Fluid Lines Connect the Air LinesOperation AdjustmentsPressure Relief Procedure Application DataClean Dispensing Valve and System Daily MaintenanceService Oil Dispensing Valve DailyRemove gun needle from valve body Air Piston, Spring and Seal Replacement Parts and Kits Double Acting Gun 24G980 Part DescriptionReplacement Parts and Kits Single Acting Gun Part Description QtyTechnical Data Double Acting Paint Gun 238377 24G980Graco Standard Warranty Graco Information