Graco Inc 311797J important safety instructions Hydraulic Oil/Filter Change, Removal

Page 16

Hydraulic Oil/Filter Change

Hydraulic Oil/Filter Change

(Figure 6)

Removal

1Relieve pressure, page 7.

2Place drip pan or rags under sprayer to catch hydraulic oil that drains out.

3Remove drain plug (2). page 26. Allow hydraulic oil to drain.

4Unscrew filter (227) slowly - oil runs into groove and drains out rear.

Installation

1Install drain plug (2) and oil filter (227). Tighten oil filter 3/4 turn after gasket contacts base.

2Fill with five quarts of Graco hydraulic oil 169236 (5 gallon/20 liter) or 207428 (1 gallon/3.8 liter).

3Check oil level.



TIA

FIG. 6

16

311797J

Image 16
Contents GH 130, GH GH 230, GH Hydraulic Sprayers Models Electric Motor Kit OptionsFire and Explosion Hazard Moving Parts Hazard Component Identification Item No ComponentGrounding SAE O-Ring Installation General Repair InformationMaintenance Pressure Relief ProcedureTroubleshooting Problem Cause Solution311797J Hydraulic Pump InstallationRemoval 227 Fan Belt Engine Removal Installation Hydraulic Motor Rebuild266 265 Test hole 288 271 Hydraulic Oil/Filter Change Displacement Pump FiguresDisplacement Pump ProConnect Slide coupler cover 193 up to fully expose rod couplersSupport pump with your hand before opening t-handle Install pin 311797J Parts All SprayersParts List All Sprayers Part Description QtyParts Drawing Engines WASHER, GH300 Parts Drawing All Sprayers Plug Parts Drawing All Sprayers GH200/230/300GH130 Ref. Part Description Qty 267 268 269 266 265 Parts List Ref. Part DescriptionGH 130 & 200 Sprayers with Spray Gun and Hoses GH 230 & 300 Sprayers with Spray Gun and HosesDimensions Sound Levels311797J 311797J Graco Standard Warranty For Graco Canada Customers