Removing and Replacing Hopper, Front and Back Covers
Back Cover
To access the motor and all other components, it is necessary to remove the hopper, front and back covers.
Removing Cover
1 Completely remove 6 screws (2 on top and each side) from cover.
ti4430a
2Lift cover up and then tilt it back and off sprayer frame.
Replacing Cover
1To reposition cover on sprayer frame, tip the cover back, toward you and slide it down, into place in the base of the frame. Then push the top back into place. Align screw holes in side and top of cover with holes in frame.
ti4432a
2Replace and tighten screws.
ti4431a
ti4433a
10 | 310645K |