4. Connect the material hose (not includ- ed), to the fluid outlet adapter.
5. Connect the barbed compression hose fitting and the 1/4" NPT compression nut to the outlet fitting.
6. Attach the atomization air hose (not included), to the air outlet fitting on the regulator.
Tank Assembly
Pump Assembly
Lift Handle
Safety Valve
Fluid Outlet Adapter
Regulator Assembly
Inlet Fitting
Outlet Fitting
Pressure Gauge
Figure 2. Lid assembly identification.
To assemble the paint tank:
1.Attach the casters to the bottom of the
paint tank.
2. Connect a 1/4 NPT air supply hose (not included), to the inlet fitting on the regu- lator (Figure 2).
3. Connect the machined compression hose fitting and the 3/8" NPT compres- sion nut to the fluid outlet adaptor.
Figure 3. Paint tank connect to air compressor and spray gun.
Install a pressure regulator (not included), between the tank regulator assembly (Figure 3) and the spray gun.
Figure 3 depicts the paint tank connected to a compressed air system with a filter/ regulator unit and a spray gun.
The filter/regulator unit will protect your tool from damaging water build-up, and allow you to adjust and maintain regulated air pressure. If you plan on installing a filter/regulator unit in your compressed air system, always follow the connection instructions that come with the unit.
Model H8226 5 Gallon Automatic Mixing Paint Tank |