7.Adjust the fluid control knob to start with a low volume of material and keep the atomization as low as possible. Use a combination of fluid control, inlet air pressure, air flow control and stroke speed to achieve the results you want. Spray so the material wets out nicely without running or sagging.
8.Use the pattern control knob to adjust the spray fan to your desired pattern.
9.Keep the gun tip perpendicular and parallel to the work surface as you spray from a distance of
��
��
11.Maintain an even speed when spray- ing.
12.Overlap each stroke by 50%. This will ensure even coverage as shown in Figure 6. Less than 50% as shown in the figure to the right may lead to missed spots or streaky results.
YesNo
Figure 6. Overlap technique.
13.Spray stroke should be consistently even with parallel edges. If it doesn't please refer to Troubleshooting on
Page 17.
14.To orient the H8115 spray gun down- ward or upward, loosen the nut that secures the cup to the gun, adjust the gun angle and tighten the nut.
10.Begin spraying 2-3 inches before the work. Continue the motion for a few inches past the work until you are ready for the return stroke.
NOTICE
Tipping the Model H8117 spray gun may cause material to spill out of the cup. Always hold the spray gun perpendicular to the ground to avoid potential spills and gravity feed prob- lems.
HEALTH & CONTAMINATION HAZARD! Dispose of paint waste in a responsible manner! Follow manufacturer's recommendations and local laws regarding disposal. Failure to comply will result in con- tamination and possibly large fines and penalties.
Model H8115/H8117 Spray Gun |