Grizzly H8117 Before Operating this Equipment, Safety Instructions for Pneumatic Tools

Page 4

SECTION 1: SAFETY

For Your Own Safety Read Instruction Manual

Before Operating this Equipment

The purpose of safety symbols is to attract your attention to possible hazard- ous conditions. This manual uses a series of symbols and signal words which are intended to convey the level of importance of the safety messages. The progression of symbols is described below. Remember that safety messages by themselves do not eliminate danger and are not a substitute for proper accident prevention measures.

Indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious injury.

 

Indicates a potentially hazardous situation which, if

 

not avoided, COULD result in death or serious injury.

 

Indicates a potentially hazardous situation which, if

 

not avoided, MAY result in minor or moderate injury.

 

It may also be used to alert against unsafe practices.

NOTICE

This symbol is used to alert the user to useful infor-

mation about proper operation of the equipment.

Safety Instructions for Pneumatic Tools

1.KEEP ALL SAFETY DEVICES IN PLACE and in working order.

2.REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of check- ing to see that keys and adjusting wrenches are removed from tool before operation.

3.KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.

4.DO NOT USE IN DANGEROUS ENVIRONMENT. Do not use pneu- matic tools in damp or wet loca- tions, or where any flammable or noxious fumes may exist. Keep work area well lighted.

5.KEEP CHILDREN AND VISITORS AWAY. All children and visitors should be kept at a safe distance from work area.

6.MAKE WORKSHOP CHILD PROOF by locking your shop and shutting off air valves.

7.DO NOT FORCE TOOL. It will do the job better and safer at the rate for which it was designed.

8.USE THE RIGHT TOOL. Do not force tool or attachment to do a job for which it was not designed.

9.DO NOT USE UNDER THE INFLUENCE OF DRUGS OR ALCOHOL.

-4-

Model H8115/H8117 Spray Gun

Image 4
Contents Mini Spray GUN Page Table of Contents Safety Instructions for Pneumatic Tools SafetyBefore Operating this Equipment Wear Approved Hearing Protection Additional Safety Instructions for Spray Guns Operating PRESSURE. doIntroduction Foreword Contact InfoTool Data Sheet SET UP H8115 AssemblyH8117 Assembly UnpackingControls Operations SprayingModel H8115/H8117 Spray Gun Atomizing Cap Fan Adjustments Set up for horizontal strokeAccessories G6261-Campbell Hausfeld Water FilterMaintenance CleaningLubrication Lubrication points, Model H8115Troubleshooting Symptom Possible Cause SolutionSymptom Possible Cause Solution Model H8115/H8117 Spray Gun Parts Breakdown H8115 REF DescriptionParts Breakdown H8117 Warranty and Returns Warranty Card Place Stamp Here