SPRAYING FOLIAGE WITH THE POWER SPRAYER WAND
MANY CHEMICALS ARE TOXIC OR
IRRITATING. READ THE SAFETY LABEL OR INSTRUCTIONS FOR EVERY CHEMICAL YOU SPRAY. CAREFULLY FOLLOW ALL INSTRUCTIONS REGARDING SKIN, EYE AND RESPIRATORY PROTECTION.
1.Prepare a mixture of chemical and water in a
NOTE: Thick or heavy chemicals must be mixed with water to reduce their thickness. Heavy materials will not pass through the Power Sprayer Wand.
2.Attach the chemical draw hose and the air hose to the Power Sprayer Wand. Place the free end of the chemical draw hose into the chemical/water mixture.
3.DO NOT attach a hose to the garden hose connector for foliage spraying. Be sure the water control knob is in the "Off" position.
4.For optimum performance set your air compressor pressure between 75 and 125 psig. Be sure the air control knob is in the "Off" position.
5.Extend the Foliage Nozzle out as far as it will go.
6.Turn on the air compressor.
7.Begin the spraying procedure by adjusting the air control knob and the soap/chemical control knob until you are spraying a mist. You may vary the mist pattern by pulling the foliage nozzle in slightly.
8.To stop spraying, turn the air control knob and the soap/chemical control knob to the "Off" position.
D20059 | 9- ENG | D20059 |